To drill the 6” laterals, the operator used a long tapered drill pipe, which tends to “whip” in the lower sections and generate harmful shocks that disrupt the sensitive electronics in the BHA. When disrupted, these electronics can cause BHA failures and necessitate the costly and time-consuming need to trip out of hole to change tools.
Expro’s 600 Series HI TOOL® Harmonic Isolation Tool is an on-bottom drilling tool that provides optimum vibration and stick-slip mitigation, BHA protection, and improved drilling efficiencies. When positioned above the LWD tool, the HI TOOL® decouples the drill string from the directional tools in the lower BHA and redistributes the vibrational energy back into the wellbore and away from the BHA. By protecting the BHA from the vibrational energy, the sensitive electronics in the BHA are not disrupted and the drill bit stays directly engaged to the formation with increased efficiency, higher revolutions per minute (RPM), and more flexible control of weight on bit (WOB) resulting in an increased rate of penetration (ROP).
Compared to the 6” upper drain section where a competitor tool was used, the operator utilized the HI TOOL® to successfully drill the lower drain section 8,375 feet in one BHA run with increased energy to the drill bit and improved drilling performance. These increased drilling efficiencies met the operator’s initial goals to reduce NPT and total rig time by saving 40 hours of drilling time compared to the upper drain section. Overall, lateral vibrations were recorded below 2G most of the run and stick-slip registered at the lowest level of severity for over 97% of the section with no vibration issues on over 93% of the run.